Rigging
GIS AG LPM/LP Electric Chain Hoist troubleshooting
The GIS AG LPM/LP Electric Chain Hoist problems live-event techs bring to Ask Roadie most. Pick your symptom, or describe your own in plain words, and get the likeliest fix first, with the manual page when there is one.
Common LPM/LP Electric Chain Hoist errors & problems
What techs run into most, and what's usually behind it. The step-by-step fix for your exact unit is in Ask Roadie.
- Step-by-step fixGet the fix →
Motor stops when hot / cuts out after repeated runs / overheating
Likely cause: The previous entry quoted a ~40% ED duty figure not found on the GIS data sheet, and assumed every hoist has a thermal trip.
- Step-by-step fixGet the fix →
Hoist completely dead / no movement in either direction
Likely cause: GIS ships the motor without control gear, so most dead-hoist calls are upstream power, phase-monitor or control-voltage faults rather than the motor itself.
- Step-by-step fixGet the fix →
Three-phase hoist runs the wrong direction / up-down reversed / limits do not stop it
Likely cause: Induction-motor direction follows phase order; restoring correct L1/L2 sequence restores commanded direction and limit-switch protection.
Not on the list? Describe it your way, or paste the error code off the display. Ask Roadie works the problem with you until it's fixed or you have a clear next move.
How Ask Roadie helps with the LPM/LP Electric Chain Hoist
- 1. Pick the GIS AG LPM/LP Electric Chain Hoist. It's already in the list.
- 2. Describe what you're seeing. In your own words, or the error code off the screen.
- 3. Get the likeliest fix first. Steps in order, the manual page when there is one, and a note when other techs have confirmed it.
- 4. Still broken? Tap 👎 and it keeps going from where you left off.
Free trial
Get your LPM/LP Electric Chain Hoist back up before doors.
Try it free. No card required.
Start free trial →