Lighting
Chauvet Maverick Force 3 Profile troubleshooting
The Chauvet Maverick Force 3 Profile problems live-event techs bring to Ask Roadie most (also called Force 3, Mav Force 3, Maverick Force). Pick your symptom, or describe your own in plain words, and get the likeliest fix first, with the manual page when there is one.
Common Maverick Force 3 Profile errors & problems
What techs run into most, and what's usually behind it. The step-by-step fix for your exact unit is in Ask Roadie.
- Step-by-step fixGet the fix →
Audible fan/electrical whine or harmonization noise in quiet TV/broadcast fan modes
Likely cause: Low PWM frequencies can beat against the reduced fan speed and create audible resonance; raising PWM above the audible range removes it.
- Step-by-step fixGet the fix →
Cooling-fan error code: Base Fan1/2/5/6, FAN1/2/5/6/7/8, JFAN1/2, XFAN, ZFAN1, or F-SPA (framing-shutter fan)
Likely cause: Chauvet error table for any fan code = check fan connection, then replace fan.
- Step-by-step fixGet the fix →
Gobo/color borders or light loss needing home alignment, or resetting one module without a full factory reset
Likely cause: Zero Adjust corrects mechanical home offset that causes gobo/color borders; a targeted Reset Function re-homes one balky module faster than a full reset.
- Step-by-step fixGet the fix →
LED_HOT error on display / output dims or shuts down (overheated LED)
Likely cause: LEDHOT is a thermal-protection trip: the 915W engine derates or cuts output to protect itself.
- Step-by-step fixGet the fix →
Pan/Tilt sensor error: X_cm1 (pan magnetic), X_op (pan optocouple), Y_cm (tilt magnetic), Y_op (tilt optocouple)
Likely cause: These are the sensors used to find home on pan and tilt.
- Step-by-step fixGet the fix →
Thermistor error: R-OPEN (open circuit) or R-SHORT (short)
Likely cause: R-OPEN/R-SHORT mean the temperature sensor reads out of range (broken or shorted).
- Step-by-step fixGet the fix →
USB firmware update will not start / USB port seems dead during update
Likely cause: Chauvet changed USB behavior in V1.260318 so the port only powers during the update menu; techs miss this and assume the slot is broken.
Not on the list? Describe it your way, or paste the error code off the display. Ask Roadie works the problem with you until it's fixed or you have a clear next move.
How Ask Roadie helps with the Maverick Force 3 Profile
- 1. Pick the Chauvet Maverick Force 3 Profile. It's already in the list.
- 2. Describe what you're seeing. In your own words, or the error code off the screen.
- 3. Get the likeliest fix first. Steps in order, the manual page when there is one, and a note when other techs have confirmed it.
- 4. Still broken? Tap 👎 and it keeps going from where you left off.
Free trial
Get your Maverick Force 3 Profile back up before doors.
Try it free. No card required.
Start free trial →