Lighting
ADJ Entour Cyclone troubleshooting
The ADJ Entour Cyclone problems live-event techs bring to Ask Roadie most (also called Cyclone fan, Entour). Pick your symptom, or describe your own in plain words, and get the likeliest fix first, with the manual page when there is one.
Common Entour Cyclone errors & problems
What techs run into most, and what's usually behind it. The step-by-step fix for your exact unit is in Ask Roadie.
- Step-by-step fixGet the fix →
Erratic/flickering fan behavior on long DMX runs or with many fixtures
Likely cause: Unterminated or improperly wired DMX lines reflect signal and pick up interference, producing erratic fan output; proper termination and shielding clean up the data.
- Step-by-step fixGet the fix →
Fuse blows when linking several units through the power throughput
Likely cause: Chaining units' power increases the current through the first unit's fuse; ADJ supplies a higher-rated 4A fuse specifically for linked-unit setups.
- Step-by-step fixGet the fix →
In 2-channel mode the fan stays off even with the speed fader up
Likely cause: The Cyclone's 2-channel profile splits speed (Ch1) and a shutter-style on/off (Ch2); a closed Ch2 overrides any speed value.
- Step-by-step fixGet the fix →
No display / unit appears dead when plugged in
Likely cause: The Cyclone has no power switch and relies on a mains fuse; a blown fuse, wrong voltage, or unseated locking connector is the usual cause of a dead display.
- Step-by-step fixGet the fix →
Reduced airflow, rattle, or noisy operation
Likely cause: Accumulated dust on blades/grilles restricts airflow and unbalances the fan; single-side removal keeps the blade assembly supported during cleaning.
- Step-by-step fixGet the fix →
Standalone speed control without a DMX console
Likely cause: The VT-1 gives a hardware speed input independent of DMX, useful for simple single-fan setups.
- Step-by-step fixGet the fix →
Top fan speed lower than expected / spec-sheet RPM confusion
Likely cause: The two official documents transpose the per-voltage RPM figures, so the safe answer is a range pending confirmation from the unit label.
- Step-by-step fixGet the fix →
Unit damaged / erratic after plugging into a dimmer
Likely cause: The motor controller needs full sine mains; a phase-cut dimmer signal can corrupt control and damage internal electronics.
Not on the list? Describe it your way, or paste the error code off the display. Ask Roadie works the problem with you until it's fixed or you have a clear next move.
How Ask Roadie helps with the Entour Cyclone
- 1. Pick the ADJ Entour Cyclone. It's already in the list.
- 2. Describe what you're seeing. In your own words, or the error code off the screen.
- 3. Get the likeliest fix first. Steps in order, the manual page when there is one, and a note when other techs have confirmed it.
- 4. Still broken? Tap 👎 and it keeps going from where you left off.
Free trial
Get your Entour Cyclone back up before doors.
Try it free. No card required.
Start free trial →