Lighting
ADJ Jolt Panel FX troubleshooting
The ADJ Jolt Panel FX problems live-event techs bring to Ask Roadie most (also called Jolt FX, Jolt Panel). Pick your symptom, or describe your own in plain words, and get the likeliest fix first, with the manual page when there is one.
Common Jolt Panel FX errors & problems
What techs run into most, and what's usually behind it. The step-by-step fix for your exact unit is in Ask Roadie.
- Step-by-step fixGet the fix →
"LED Fan Error" or "Temperature Error" shown in the menu / fixture running hot or shutting down
Likely cause: The panel self-monitors LED-fan rotation and internal temperature; blocked airflow or a failed fan trips these errors and can force a protective shutdown.
- Step-by-step fixGet the fix →
Fixture reverts from 141ch (or other high-channel) mode to 6ch / default mode after a power cycle
Likely cause: The mode only persists if the menu selection is committed and backed out.
- Step-by-step fixGet the fix →
How to update firmware / software on the Jolt Panel FX
Likely cause: The fixture reads the firmware image directly from the USB service port; stray files on the drive can cause the wrong image to load, so the drive must contain only the intended update.
- Step-by-step fixGet the fix →
Menu is locked / display backlight keeps turning off / settings changed unexpectedly
Likely cause: What looks like a frozen or randomly-changing panel is usually the display lock/backlight timeout or an accidental service-menu edit; knowing the lock behavior and passcode-gated Service menu explains and resolves it.
- Step-by-step fixGet the fix →
No response to DMX / wrong fixtures respond / erratic behavior on a daisy chain
Likely cause: Overlapping/incorrect start addresses make fixtures share or ignore channels; mismatched modes shift every downstream address.
- Step-by-step fixGet the fix →
Panel goes dark / holds last look when the DMX signal drops or the console is unplugged
Likely cause: The fixture has a selectable data-loss mode; the "dead" or "frozen" behavior is just whichever No-DMX Status is configured, not a fault.
- Step-by-step fixGet the fix →
Visible flicker on camera or when RGB pixels are partially dimmed
Likely cause: LED strobe/wash panels are PWM-driven; a refresh rate that beats against the camera shutter reads as flicker.
Not on the list? Describe it your way, or paste the error code off the display. Ask Roadie works the problem with you until it's fixed or you have a clear next move.
How Ask Roadie helps with the Jolt Panel FX
- 1. Pick the ADJ Jolt Panel FX. It's already in the list.
- 2. Describe what you're seeing. In your own words, or the error code off the screen.
- 3. Get the likeliest fix first. Steps in order, the manual page when there is one, and a note when other techs have confirmed it.
- 4. Still broken? Tap 👎 and it keeps going from where you left off.
Free trial
Get your Jolt Panel FX back up before doors.
Try it free. No card required.
Start free trial →