Lighting
ADJ Mirage Q6 PAK troubleshooting
The ADJ Mirage Q6 PAK problems live-event techs bring to Ask Roadie most. Pick your symptom, or describe your own in plain words, and get the likeliest fix first, with the manual page when there is one.
Common Mirage Q6 PAK errors & problems
What techs run into most, and what's usually behind it. The step-by-step fix for your exact unit is in Ask Roadie.
- Step-by-step fixGet the fix →
New/stored units show short runtime or won't reach rated battery life
Likely cause: The fuel-gauge only reads accurately after a full charge + initialization; skipping it (or updating firmware) leaves the gauge uncalibrated so it reports short and cuts out early.
- Step-by-step fixGet the fix →
Colors or dimming behave wrong / controller channels don't line up
Likely cause: DMX is positional: the fixture interprets incoming slots based on its selected personality, so an unmatched channel-count mode shifts every parameter.
- Step-by-step fixGet the fix →
Fixture is dead / won't power on after long storage
Likely cause: Lithium packs enter a protective low state when deeply discharged; a short charge restores enough voltage for the fixture to boot, and periodic top-ups prevent the deep-discharge state.
- Step-by-step fixGet the fix →
Battery Saver Mode 14 option is missing from the menu
Likely cause: The feature is firmware-gated; only builds V1.03 and later include the Saver Mode 14 menu entry.
- Step-by-step fixGet the fix →
How do I update firmware / fixture menus on the Mirage Q6?
Likely cause: OTA via the BLE app is ADJ's supported path to keep Aria radio, fixture firmware, and menus current without a wired programmer.
- Step-by-step fixGet the fix →
Using the Mirage Q6 outdoors / IP65 handling
Likely cause: IP65 covers dust-tight + water-jet resistance only; submersion or open ports exceed the rating and let water reach the electronics.
- Step-by-step fixGet the fix →
Fixtures won't link to the controller wirelessly (WiFLY / Aria X2)
Likely cause: The pak only responds when the fixture and the transmitter share the same wireless protocol and ID/network; a mismatched WiFLY ID or unpaired Aria device leaves the fixture listening on the wrong channel.
Not on the list? Describe it your way, or paste the error code off the display. Ask Roadie works the problem with you until it's fixed or you have a clear next move.
How Ask Roadie helps with the Mirage Q6 PAK
- 1. Pick the ADJ Mirage Q6 PAK. It's already in the list.
- 2. Describe what you're seeing. In your own words, or the error code off the screen.
- 3. Get the likeliest fix first. Steps in order, the manual page when there is one, and a note when other techs have confirmed it.
- 4. Still broken? Tap 👎 and it keeps going from where you left off.
Free trial
Get your Mirage Q6 PAK back up before doors.
Try it free. No card required.
Start free trial →